This tutorial shows you in easy steps how the recording process in Live 9 works. If you want to record real instruments or vocals, you should consider getting a decent audio interface as a built-in sound card won't give you the quality, but high latencies instead which means you'll hear an annoying delay while recording.
- In an Audio Track choose 'Ext. In' under 'Audio From' as well as the Input that you've connected the cable to on your interface, e.g. 1. Most input sources are mono so if you can only choose 1/2 you need to go to the Preferences > Audio > Input Config and activate the Mono Inputs first. Otherwise you'll end up with the recorded signal playing back only on one side.
- Arm the Audio Track. Plug your headphones into the headphones output of your audio interface or computer. If you want to hear what you sing or play, turn Monitoring to Auto.
- Now test the input levels by playing/singing. You want to get a properly loud signal without having the meters go into the red. Red means it's too loud and you'll get nasty digital distortion. If your audio interface has a knob next to the input, you can adjust the input level there. If not, you should have a mixing software in which this can be set. If in doubt, refer to interface's manual.
- Once you've established a good level for your recording you should set the Tempo and Time Signature. You can either enter the BPM directly or tap out the tempo by hitting the Tap Tempo button for each beat. You can click on the Time Signature to change it.
- To record in sync with the tempo, turn on the Metronome.
- You can also set a count-in to have some time to get ready before the recording starts. For this open the Preferences > Record/Warp/Launch and choose 1, 2 or 4 Bars for the Count-In.
- You can either record into Session or Arrangement View. The former is good for jamming and trying out ideas in loops, the latter for continuous recordings.
- To record into Arrangement View, you only need to click on the Global Record button.
- If you want to record into Session View, there are two methods:
- Click the Session Record button (next to New) to start recording. Click it again to go back into playback.
- You can click the Record button in a Clip Slot to start recording.
- To stop playback and prepare for a new take, press the New button. This stops the clips in all armed tracks, selects the next empty scene or creates a new one if none is available anymore.
- Press the Spacebar again once you're done with recording. The Clip View at the bottom of Live includes the Sample Editor that now contains the waveform you've recorded. To see the Clip View of a clip, it needs to be selected. If it's not, double-click the clip to make it visible.
Any questions, suggestions or other comments? I'm happy to read them. :)
There are plenty more Ableton Live tutorials where this one came from.